CMH53C EDM Machine
1.Capable to read DXF file from AUTOCAD and transform to NC program directly.
2.NC program is compatible with Wire Cut working program. Without further
amendment it can begin to work from start point of wire cut program.
3.Optimum machining program can be called out automatically upon inputting
thinkness of workpiece, and wear rate.
4.Network capability (option).
CMH32A EDM Machining
1.Make starting holes for wire-cutting.
2.Drill small & deep holes on extra hard steel, alloy, metallizer, power
metallurgy and on metals that ordinary drilling machine unable to work on.
3.Able to drill small & deep holes on spherical curved and irregular
working surface.
4.Work table is made of stainless steel.
5.Z axis equipped with precise ballscrew to obtain high stability and high
speed machining.
6.Material for electrode tube can be either brass or copper.
7.Dielectric fluid can be either water or distilled water, as far as low
cost is concerned.
8.Sodick patents licensed.
CM655Z EDM Machines
1.14"VGA display of position and power settings.
2.3-Axis DRO with .001mm(.00004") resolution.
3.Inch/metric switchable.
4.Programmable Z axis allows powersetting changes along the Z axis travel.
This allows for roughing, semi-finishing and fine finishing without operator
intervention.
5.Edge finding and center finding from two edges.
6.Built in Anti-Arc protection.
CM-A53CP EDM Machining
1.Patent powder-added fluid improves stability and efficiency on large-size
workpiece.
2.By powder-added technology to increase the sparking gap avoiding arcing
happened. Separated sparking to let stable height speed finishing and
attain mirror surface.
3.High self-productivity included machine body, controller and software
to lead quick and easy service.
4.Adjustable jumping distance and speed, to maximize to 1.8m/min.
5.All in one compact design, easy installation and saving space.
6.New generation powder EDM with state-of-the-art tank efficiently separates
powder and residual moreover maintaining the concentration rate improving
stable sparking.
CWP53S EDM Machines
1.All-in-One compact design, floors by 1.8!N1.8m, adapts in any plant.
2.Easy to install just by plugging power line in.
3.Separated XY for balancing the load of motors and maintaining high precision
when surface finish, Strong UV on the column for consistent precision under
dielectric pressure.
4.Cutting conditions were made automatically after inputting wire diameter,
workpiece material and thickness and cutting mode.
5.Easy to operate the seccon, the third and the fourth cuts, particularly
access the second cut automatically.
6.Memorized cutting data and coordinates if power failure.
